Home  Sitemap  Terms


ABOUT PRODUCTS SOLUTIONS SUPPORT NEWS CONTACT
  Top » Catalog » MS Injector Drivers » EMG-4-001 My Account  |  Cart Contents  |  Checkout   

Categories
MegaSquirt ECU's
MS Accessories
MS Connectivity
MS Injector Drivers
MS Input Modules
MS MAP Sensors
MS Temp. Sensors
MS Software
O2 Sensor Sims
Fuel Cut Defenders
Manifolds
Wideband Systems
SymTech Labs Gear
Services->
Shopping Cart more
0 items
Notifications more
NotificationsNotify me of updates to Peak & Hold Injector Driver Board
Information
Terms & Conditions
Shipping & Returns
Warranty & Usage Information
Privacy Notice
Contact Us
Peak & Hold Injector Driver Board
[EMG-4-001]
$124.99

SymTech Labs' Peak & Hold Fuel Injector Driver (PH Driver) Board efficiently drives low impedance, or "peak and hold" fuel injectors. Low impedance fuel injectors are preferred by automotive designers and enthusiasts over the lower quality high impedance, or "saturated" fuel injectors. The SymTech Labs PH Driver is the only way to control these injectors to meet your engine's demanding fueling needs.

Designed for use with MegaSquirt EMS systems, the SymTech Labs PH Driver can be used to supplant the outdated injector drivers on either v2.2 or v3.0 boards. Either inline injectors resistors or a SymTech Labs PH Driver must be installed in order to use low impedance fuel injectors with a v2.2 board or an MS1 processor and the MS1/Extra High-Resolution (HR) firmware. Unlike inline resistors, the PH Driver uses a specialized network of chips with peak and hold technology to quickly and precisely control low impedance fuel injectors.

The PH Driver offers four independent channels, one for each fuel injector, perfect for use with sequential injection and MS2 with the MS2/Extra firmware, or MS3. For applications requiring more than four fuel injectors, multiple boards can be installed.

There are no tricky PWM settings to calibrate, since the onboard chips limit current draw through each injector on the fly. The PH Driver compensates for low voltage conditions (cold weather, startup, etc.), and even eliminates the radio frequency interference (RFI) characteristic of the standard MegaSquirt fuel injector drivers. The PH Driver is optimized for use with 4A peak and 1A hold low impedance fuel injectors. The board comes fully assembled and contains virtually all surface mount devices (SMD), which are less prone to failure due to vibration. The board is designed to fit a standard width (~4") MegaSquirt ECU enclosure.

This product was added to our catalog on Wednesday 31 March, 2010.
Reviews
Customers who bought this product also purchased
Bosch LSU 4.2 Wideband O2 Sensor
Bosch LSU 4.2 Wideband O2 Sensor
Cam Sync Module (VR)
Cam Sync Module (VR)
MegaSquirt Sequential Injection Kit
MegaSquirt Sequential Injection Kit
MegaSquirt Intake Air Temperature (IAT) Sensor
MegaSquirt Intake Air Temperature (IAT) Sensor
MegaSquirt MS2 EMS ECU
MegaSquirt MS2 EMS ECU
Innovate LC-1 Wideband Controller Kit
Innovate LC-1 Wideband Controller Kit

Copyright 2006-2009 SymTech Laboratories. All Rights Reserved.

Home : About Us : Products : Solutions : Support : News : Contact Us
Terms : Copyright & Legal : Privacy Policy : Site Map